The inclination angle when installing the three-cylinder dryer

How to determine the inclination angle when installing a three-cylinder dryer
There are many models of dryers, and the range of materials that can be selected for drying is also very wide, and there are many types. You should choose the model that suits you mainly according to your actual needs. In this way, the selection will meet the needs of your work and improve productivity.
When installing the dryer, there must be an inclined angle. This is required by the scope. How is this angle determined during installation? At what angle can the device not slide down?
1. The moisture content of the raw material and the rotation speed of the dryer determine the angle of the dryer. The normal angle is 3-6 degrees.
2. During the installation and debugging of the equipment, the middle line of the supporting roller and the middle line of the cylinder body should be adjusted to be non-parallel to make a suitable angle. What is the inclination angle? The body produces an axial velocity, that is, an axial force offsets the downward force of the cylinder, and the sand and gravel lines make it difficult for the cylinder to move axially.
The benefits of increasing the hot air flow rate of the dry powder mortar dryer
1. Improve the hot gas flow of the dryer and increase the flow rate of the hot gas, which can increase the working efficiency of the lifting plate.

2. Improving the airflow speed of hot air plays a very important role in accelerating the heat speed.
3. To increase the velocity of hot air, it is necessary to design a reasonable exhaust air and dust removal system at the end of the dryer and a hot air supply system at the head end.
4. The total pressure and air volume of the exhaust fan must be appropriate. If the total pressure is too low and the air volume is too small, it will directly affect the exhaust air and reduce the output of the dryer; if the total pressure is too high and the air volume is too large, it will directly increase Power loss, and it will also increase the temperature of the exhaust gas off the machine, increasing the heat loss.
Fifth, to increase the insulation of the cylinder, use a boiling furnace for heating, and increase the temperature gradient.
6. The speed and flow of the hot air and the drying effect of the dryer will be directly induced during the operation. The drying speed of the dryer is also affected by the hot air. Controlling the hot air plays a decisive role in drying materials.
7. Strengthen the insulation of the cylinder body, use a boiling furnace for heating, increase the temperature difference between the atmosphere and the solid phase, and increase the temperature gradient.
8. Increase the heating area of the solid phase.