How to maintain the three-cylinder dryer daily

How to maintain the three-cylinder dryer daily? Jiangsu Leijin three-cylinder dryer manufacturers analyze for you:
1. The shaft bears the full load of the negative machine, so good lubrication has a great relationship with the life of the bearing, which directly affects the service life and operation rate of the machine. Therefore, the injected lubricating oil is required to be clean and well sealed. The main oil injection of this machine is Location: (1) Rotary bearing (2) Roll bearing (3) All gears (4) Active bearing, sliding plane.
2. The newly installed tires are prone to loosening and need to be checked frequently.
3. Pay attention to whether the work of each part of the machine is normal.
4. Pay attention to check the wear degree of the wear-resistant parts, and pay attention to replace the worn parts at any time.
5. On the bottom frame plane of the movable device, dust and other objects should be removed to prevent the movable bearing from moving on the chassis when the machine encounters materials that cannot be broken, resulting in serious accidents.
6. If the bearing oil temperature rises, stop immediately to check the cause and eliminate it.

When choosing dryer equipment, it is necessary to clarify what materials are to be dried, and choose dryer equipment according to the characteristics of the materials, such as sand and gravel required for infrastructure construction. When drying sand and gravel, care should be taken not to dry it. Excessive, otherwise it is likely to affect the function of the essence of the stone, resulting in a weak building. There are many factors that affect the drying effect, including temperature, material properties, airflow speed, etc. The air velocity affects the time the material stays in the dryer barrel and the degree of contact with the hot air. Under the condition that the hot air is relatively stable and the airflow speed reaches the optimum state, the higher the drying efficiency is, the shorter the heating time is. This requires the manufacturer to design the drying cylinder of the dryer equipment reasonably and adjust the airflow speed to the best stability. status. Hot air is the dominant force in the drying effect of the dryer. If the moisture content of the material is greater, the energy consumed will be greater, and the required hot air will be stronger. Because of the hot air, the cylinder will generate pressure, and the longer the cylinder, the hotter the air will be. The greater the air volume required to pass through the cylinder, the more moisture is removed, and the better the drying effect. The ambient temperature also has a certain influence on the drying effect. The ambient temperature directly affects the speed of hot air supply. When the ambient temperature and humidity are high, the water vapor will gradually become saturated, which is beneficial to the dryer. Therefore, the drying effect of the dryer has a great relationship with the heat exchange effect in the drum.