How to adjust the dryer?

How to adjust the dryer?
The three-cylinder dryer manufacturer guarantees the ventilation volume of the sand dryer. Of course, it is necessary to grasp the temperature of the dryer at any time, and some materials must be added according to the fuel to achieve the state of energy-saving drying. The dryer is in the ventilation place, in fact, it is mainly between the drying cylinder and the hot blast stove. The following editor will talk about it with you.
The key parts for managing the best-selling exhaust air are the flap valve and the flashing valve. Only by operating these two parts well can the exhaust air be smooth and well ventilated. First of all, we must learn to judge by ourselves whether the ventilation is good or bad. We use a simpler method. First, we wet our hands, and then extend our hands to the outlet. In this case, if the water on the hands evaporates after a while, it means that the ventilation is good, otherwise the ventilation is not good and needs to be adjusted. Of course, this is only a simpler and more effective judgment method.

The adjustment of ventilation volume can be debugged in the following ways:
1. Pay attention to the air leakage between the flaps, especially the sealing of the bearing parts. And prevent the large slag, bricks, iron wire and other debris from falling into the flap valve. Causes deep wind, and even hinders the discharge or jams the flap, which cannot be turned over.
2. Observe how much the flap valve is blanking and the size of the blanking interval, whether it is compatible with the discharging speed of the sludge dryer. Do not store too much material in the tipper to affect the discharge. Don't store too little material, and the vibration must be complicated.
3. Refuel the shaft oil cup on time. Twist 1~2 times per shift, and you can rotate one button every time. For the flash valve, it is necessary to observe whether the operation is flexible, whether the feeding is smooth, whether the position of the counterweight is appropriate, and whether the triangular cone is in tight contact with the feeding nozzle. The counterweight can be adjusted appropriately according to the condition of ash accumulation and feeding. The triangular cone is usually movably linked to the lever. In order to prevent the flashing from shifting due to vibration, it can also be fixed and welded on the lever after aligning the discharge nozzle.